Alarm, probe active or door/E-stop blocks

Resolve the reported input or state before trying the action again.

Step by step

1. Read the actual status and blocking message. Check the physical cause of a door, limit, probe or alarm input.
2. Remove the probe and clip from the cutting area when probing has finished and confirm the input is released.
3. Inspect wiring and the configured input polarity through the commissioned setup procedure if the displayed state is unexpected.
4. Use the approved reset/unlock/home procedure for the cause. Unlocking is not a replacement for finding the fault.
5. If the link or position reference was lost during a job, use Recovery after reconnecting.

Learning progress records reading, not physical commissioning or authorisation to operate.