Probe stock Z and establish work zero

Use fresh measured contact results with the cutter actually fitted.

Step by step

1. Home and enable the required setup controls. Select the correct probe routine in Probe & Setup.
2. Enter the real probe geometry, approach distance, feeds and safe clearance. Review the planned approach and retract.
3. Check the probe input in its released and contacted states as requested. Position the probe and connect its clip according to the probe manufacturer's instructions.
4. Explicitly run the reviewed routine. Inspect the contact result and repeatability; a failed or cancelled probe does not establish a datum.
5. Apply work zero from the fresh measured result to the intended WCS. For a saved XY fixture, use a Z routine so XY is retained.
6. Remove the probe and clip from the work area. Confirm the input is released, then review the job again.

Learning progress records reading, not physical commissioning or authorisation to operate.